Reply To: Temp Problem

Forums 3D Printers Cube 3 Temp Problem Reply To: Temp Problem

#71
K.H.MusicMan

Thank you for the reply,

But the tip you mentioned didn’t work for me. I literally have to stop the bigger fan at the top, then it will begin to extrude/purge/start the print. However, after about 10 mintues it gives me the temp T14 or T24 error. I only have an ABS cartridge right now, but I will try it with my PLS cartridge when it comes in on Friday.

Thank you again, let me know if you have any more tips…

Always appreciated…

  • This reply was modified 4 months, 1 week ago by No BullNo Bull.