Filament hack - 100%

Post Reply
K.H.MusicMan
Posts: 7
Joined: Tue Jun 12, 2018 7:12 am

Filament hack - 100%

Post by K.H.MusicMan » Tue Jun 12, 2018 8:58 pm

I have the firmware with the filament hack installed on my cube printer. All of my cartridges were below 100% at one point. However, something stranged happened... one of my ABS cartridges changed to 100%. Now I can't use the ABS cartridge, how do I get the cartridge to read below 100%? Do I have to install the latest firmware and then reinstall the filament hack firmware?

Thanks all.
User avatar
MajorOCD
Site Admin
Posts: 28
Joined: Sat May 05, 2018 10:01 pm

Re: Filament hack - 100%

Post by MajorOCD » Tue Jun 12, 2018 11:15 pm

Unless you have the "Re-Cube" from Tomuro, yes. I have done it myself a few times to initialize a new cartridge. I had to flash it back to original firmware, load new cartridge from the printer's menu (which changes it to 99%), then flash it back to the hack.

I've never heard of a cartridge reverting to 100%. I wonder what happened?
K.H.MusicMan
Posts: 7
Joined: Tue Jun 12, 2018 7:12 am

Re: Filament hack - 100%

Post by K.H.MusicMan » Wed Jun 13, 2018 12:50 pm

Okay, I guess I'll put the most recent firmware, then put the hack back on later.
Post Reply